Yeah, sorry. I'm a little more than frustrated. I haven't even had a chance to use this thing yet and the number of problems I have encountered is insane.
Yep, I've done the 30 second touch thing about 50 times now. In the rare chance that it allows me to actually choose either factory reset or reset screen calibration (usually it throws me right into controller 2 setup screen ?), I choose reset screen calibration and hold it for 5 seconds. It pops me out in the Moel_T settings settings screen. Once I am here the screen calibration is so bad, that I cannot even choose any of the buttons. When I go to press the buttons for say screen calibration or any of the options, it scrolls me up and down. Therefore, it thinks that I am pressing the arrows as opposed to the button choices. That is a good 2-3 inches off on the screen. If I wanted to have it think I was pressing the option buttons I would be pressing the air 2-3 inches off top the of the model-T.
Sorry for the frustration. I bought this unit for more control and monitoring of my processes and ditched my Ranco controllers. It's not turning out so well.