I've used the pid settings previously, but have never noticed this much variation in my device, definitely not a 4.5 degree jump.
Anyone know what could have caused this?
Would I be better to just stick with hysteresis to avoid?
That is really strange, I will have to look into that. However, if you are using this to control a compressor based system (fridge/freezer), the on/off mode with a compressor delay and hysteresis would be more ideal to prevent cycling the compressor as often.
I am actually using this to control pumps that push glycol (temp controlled by a separate compressor based unit).
I may try the on/off.
Here is the overall fermentation. Really unsure why it has jumps like this.
Can you attach a link to your session plot?
What are all the different session settings that you are using?
What version of software is your unit running, you can see this by going into the info screen under the settings menu.
